TK Products Bright Glaze (5-Gallon Pail)

TK-BRIGHT GLAZE is a blend of 100% methyl/methylacrylate polymers used as a superior and specialized compound for
curing and sealing exposed aggregate, stamped/stenciled concrete and other decorative concrete and masonry surfaces.
Formulated with higher viscosity (thickness) than standard curing and sealing compounds, TK-BRIGHT GLAZE is for applications where a glossier, one-coat finish is desired. 

Features:

• Coating dries clear and does not yellow with age or exposure to ultraviolet rays.
• Provides superior protection against freeze/thaw cycles, deicing salts, and chemical erosion and efflorescence.
• Reduces the possibility of aggregate popouts on exposed aggregate by percolating down and around the stones to fill gaps and voids.
• Forms a durable long-lasting film with resistance to water, chemicals, abrasion and stains.
• Highlights and preserves the natural pigments in the surface, adding longevity and sparkle to the finished product.
• Does not discolor with over-use.

USES:
Suitable for interior or exterior use on new or existing architectural concrete, burnish block, terrazzo, brick, stone, slate, quarry tile or other cementitious materials. Ideal for exposed aggregate and colored concrete surfaces, paving block, patio stone, driveways and garage floors.

APPLICATION PROCEDURES:
PREPARATION:
Surfaces must be clean, dry and free of form oils, grease, dust, frost and curing compounds (particularly wax based). Large areas may be blown dust free by compressed air, washed and let dry. Surface water must be allowed to completely dissipate before applying.

Exposed Aggregate Application Preparation - When applying to exposed aggregate as a curing compound, the surface should be washed with a mild acid solution to remove the thin film of cement dust, then flushed with water and allowed to dry before applying TK-BRIGHT GLAZE.

At this point a small mock-up area should be applied in an inconspicuous location to test the compatibility of the coating
with the prepared substrate. Allow the coating to dry and cure fully, then inspect for proper film formation, gloss, adhesion and confirm that the film is free from whitening or any other defects.

MIXING:
The material is ready for use and requires no mixing or dilution. It is unlawful to further dilute with non-exempt solvents.

APPLICATION:
TK-BRIGHT GLAZE WILL DARKEN CONCRETE.
Apply with a brush, roller or long nap applicator. Work the compound into the concrete avoiding accumulations, puddling, runs or sags. On large areas, an airless sprayer may be used.

Note that concrete must be fully cured (looks uniform in color) and dry at the time of application. This eliminates the possibility of moisture becoming trapped between the film and the concrete slab, resulting in a white haze on the surface. If a white haze does develop, an application of TK-00 XYLENE* will dissolve the film and allow trapped moisture to escape. TK-BRIGHT GLAZE will then be able to reharden clearly.

CLEAN UP:
Use TK-00 XYLENE* to clean tools and equipment. Pump solvent through the sprayer to remove residue of materials which can clog the hose and wand assembly.

COVERAGE:
Curing Exposed Aggregate: 300-500 sq.ft./gal
Second coat, cured concrete, burnished block: 300-500 sq.ft./gal

Coverage rates are provided as a guideline only. Many factors including surface texture, porosity and weather conditions will determine actual coverage rates.

MAINTENANCE:
Minimal maintenance is required other than occasional sweeping, dusting or mopping. If wear patterns do occur or if spillage removes the coating, TK-BRIGHT GLAZE may be reapplied to the affected area(s).

View Data Sheets and hazards on manufacturer's website.